Aix iscsi driver

 · Install AIX on hdisk. You will see: bash# lsdev -Cc disk hdisk0 Available SAS Disk Drive hdisk1 Available SAS Disk Drive hdisk2 Available Other FC SCSI Disk Drive. You can then install the PURE ODM definition. Reboot, as prompted by the tool. PURE will have replaced the Other FC drive.  · iSCSI protocol driver during configuration. After the software initiator is configured, do the following: 1. Edit the */etc/iscsi/targets* file to include the iSCSI targets needed during device configuration. Each uncommented line in the file represents an iSCSI target. iSCSI device configuration requires that the iSCSI targets can be reachedEstimated Reading Time: 5 mins.  · Subject: RE:[ibm-aix-l] Setup iSCSI on AIX Subject: RE:[ibm-aix-l] Setup iSCSI on AIX. Posted by bassemir (Senior Software Engineer) on Oct 1 at PM Mark as helpful. It has been a while but when I set up iSCSI it was for a NetApp box and they had a host attach kit that included pretty detailed instructions on how to set it up.

The iSCSI software target driver enables AIX to act as one iSCSI target device or as several iSCSI target devices. The iSCSI target driver exports local disks, logical volumes, or local files to iSCSI initiators that connect to AIX using the iSCSI protocol and TCP/IP. iSCSI software initiator considerations. AIX has a tunable parameter to set the threshhold for what is a "large" packet and what is a "small" packet to the Nagle algorithm. When set to bytes, it forces the typical 2KB iSCSI data segment to be considered a “large” packet and so it is sent immediately. The AIX command to set the Nagle limit to is: # no -o tcp_nagle_limit= Subject: RE:[ibm-aix-l] Setup iSCSI on AIX Subject: RE:[ibm-aix-l] Setup iSCSI on AIX. Posted by bassemir (Senior Software Engineer) on Oct 1 at PM Mark as helpful. It has been a while but when I set up iSCSI it was for a NetApp box and they had a host attach kit that included pretty detailed instructions on how to set it up.

Verify that the Initiator Name value is correct. The initiator name value is used by the iSCSI target during login. The name must match the iSCSI name that was. 30 de jun. de /etc/iscsi/targets file configures each configured target that an AIX system's iSCSI driver will use. There is also an option to store this. AIX 一般已自带了iscsi initiator，可用$ lslpp -L|grep -i iscs 命令查看：. www.doorway.ru C F Common iSCSI Files.